Enterasys C3G124-24 - Enabling; Disabling Jumbo Frame Support; Purpose; Commands; Show Port Jumbo

Enabling / Disabling Jumbo Frame Support
Enterasys C3 Configuration Guide 11-13
Enabling / Disabling Jumbo Frame Support
Purpose
To review, enable, and disable jumbo frame support on one or more ports. This allows Gigabit
Ethernet ports to transmit frames up to 10 KB in size. LAG ports can also be configured for jumbo
frame support.
Commands
show port jumbo
Use this command to display the status of jumbo frame support and maximum transmission units
(MTU) on one or more ports.
Syntax
show port jumbo [port-string]
Parameters
Defaults
If port-string is not specified, jumbo frame support status for all ports will display.
Mode
Switch command, read-only.
Example
This example shows how to display the status of jumbo frame support for ge.1.1:
C3(su)->show port jumbo ge.1.1
Port Number Jumbo Status Max Frame Size
------------- --------------- ------------------
ge.1.1 Enable 9216
For information about... Refer to page...
show port jumbo 11-13
set port jumbo 11-14
clear port jumbo 11-14
port-string (Optional) Displays the status of jumbo frame support for specific
port(s). For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 11-1.