Enterasys C3G124-24 - Clear Spantree Spanguardtrapenable; Show Spantree Legacypathcost

clear spantree spanguardtrapenable
Enterasys C3 Configuration Guide 13-31
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to disable the SpanGuard trap function:
C3(su)->set spantree spanguardtrapenable disable
clear spantree spanguardtrapenable
Use this command to reset the Spanning Tree SpanGuard trap function back to the default state of
enabled.
Syntax
clear spantree spanguardtrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to reset the SpanGuard trap function to enabled:
C3(rw)->clear spantree spanguardtrapenable
show spantree legacypathcost
Use this command to display the default Spanning Tree path cost setting.
Syntax
show spantree legacypathcost
Parameters
None.
disable | enable Disables or enables sending SpanGuard traps. By default, sending traps
is enabled.