Enterasys C3G124-24 - Tunnel Source

tunnel source
Enterasys C3 Configuration Guide 25-9
Mode
Router global configuration mode: C3(su)->router(Config)#
Usage
This command enables tunnel interface configuration mode from global configuration mode, and,
if the interface has not previously been created, this command creates a new tunnel routing
interface.
The no form of this command removes the tunnel interface and associated configuration
parameters.
Example
This example creates a configured tunnel interface 1.
C3(su)->router(Config)# interface tunnel 1
C3(su)->router(Config-if(Tnnl 1))#
tunnel source
This command specifies the IPv4 source transport address of the tunnel.
Syntax
tunnel source {ipv4-addr | interface vlan vlan-id}
no tunnel source
Parameters
Defaults
None.
Mode
Router interface configuration: C3(su)->router(Config-if(Tnnl 1))#
Usage
The no form of this command removes the source IPv4 address for the tunnel interface being
configured.
Example
The following example configures the source IPv4 address for tunnel 1.
C3(su)->router(Config)# interface tunnel 1
C3(su)->router(Config-if(Tnnl 1))#
C3
(su)->router(Config-if(Tnnl 1))# tunnel source 192.168.10.10
ipv4-addr The IPv4 source address of the tunnel.
interface vlan vlan-id Specify an interface to use a link-local address. The VLAN must be
configured in switch mode.