Enterasys C3G124-24 - Set Spantree Mstcfgid; Clear Spantree Mstcfgid

set spantree mstcfgid
Enterasys C3 Configuration Guide 13-17
set spantree mstcfgid
Use this command to set the MST configuration name and/or revision level.
Syntax
set spantree mstcfgid {cfgname name | rev level}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to set the MST configuration name to “mstconfig”:
C3(su)->set spantree mstconfigid cfgname mstconfig
clear spantree mstcfgid
Use this command to reset the MST revision level to a default value of 0, and the configuration
name to a default string representing the bridge MAC address.
Syntax
clear spantree mstcfgid
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to reset the MST configuration identifier elements to default values:
C3(su)->clear spantree mstcfgid
cfgname name Specifies an MST configuration name.
rev level Specifies an MST revision level. Valid values are 0 - 65535.