set spantree
13-8 Spanning Tree Configuration
set spantree
Use this command to globally enable or disable the Spanning Tree protocol on the switch.
Syntax
set spantree {disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to disable Spanning Tree on the device:
C3(su)->set spantree disable
show spantree version
Use this command to display the current version of the Spanning Tree protocol running on the
device.
Syntax
show spantree version
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display Spanning Tree version information for the device:
C3(su)->show spantree version
Force Version is mstp
disable | enable Globally disables or enables Spanning Tree.
To Next Page
Loading...
