Enterasys C3G124-24 - Show Arpinspection Ports; Show Arpinspection Vlan

show arpinspection ports
23-24 DHCP Snooping and Dynamic ARP Inspection
show arpinspection ports
Use this command to display the ARP configuration of one or more ports.
Syntax
show arpinspection ports [port-string]
Parameters
Defaults
If a port-string is not specified, information about all DAI-enabled untrusted ports is displayed.
Mode
Switch command, read-write.
Example
This example displays the ARP configuration of lag.0.1.
C3(su)->show arpinspection ports lag.0.1
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
---------- ------------- ------------- ---------------
lag.0.1 No 15 1
show arpinspection vlan
Use this command to display the ARP configuration of one or more VLANs.
Syntax
show arpinspection vlan vlan-range
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example displays ARP configuration information for VLAN 5.
C3(su)->show arpinspection vlan 5
Source MAC Validation Disabled
Destination MAC Validation Disabled
port-string (Optional) Specifies the port or ports for which to display ARP
configuration information.
vlan-range Specifies the VLANs for which to display configuration information.