Enterasys C3G124-24 - Show Eapol

show eapol
Enterasys C3 Configuration Guide 32-25
This example shows how to reset the 802.1X quiet period to 60 seconds on ports ge.1.1-3:
C3(su)->clear dot1x auth-config quietperiod ge.1.1-3
show eapol
Use this command to display EAPOL status or settings for one or more ports.
Syntax
show eapol [port-string]
Parameters
Defaults
If port-string is not specified, only EAPOL enable status will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display EAPOL status for ports ge.1.1-3:
C3(su)->show eapol ge.1.1-3
EAPOL is disabled.
Port Authentication State Authentication Mode
-------- -------------------- --------------------
ge.1.1 Initialize Auto
ge.1.2 Initialize Auto
ge.1.3 Initialize Auto
Table 32-2 provides an explanation of the command output. For details on using the set eapol
command to enable the protocol and assign an authentication mode, refer to “set eapol” on
page 32-27.
port-string (Optional) Displays EAPOL status for specific port(s). For a detailed
description of possible port-string values, refer to “Port String Syntax Used
in the CLI” on page 11-1.