area nssa translator-stab-intv
Enterasys C3 Configuration Guide 31-15
Example
This example configures the router to always assume the translator role when it becomes an area
border router for NSSA 20.
C3(su)->router(Config-router)# area 20 nssa translator-role always
area nssa translator-stab-intv
This command configures the translator stability interval of the NSSA.
Syntax
area areaid translator-stab-intv interval
no area areaid translator-stab-intv
Parameters
Defaults
The default interval is 40 seconds.
Mode
Router OSPFv3 configuration: C3(su)->router(Config-router)#
Usage
The stability interval is the period of time that an elected translator continues to perform its duties
after it determines that its translator status has been deposed by another router.
Example
This example sets the translator stability interval to 60 seconds for NSSA 20.
C3(su)->router(Config-router)# area 20 nssa translator-stab-intv 60
area range
This command creates an address range for the specified NSSA.
Syntax
area areaid range ipv6-prefix/prefix-length {summarylink | nssaexternallink}
[advertise | not-advertise]
no area areaid range ipv6-prefix/prefix-length
areaid Specifies the area ID in IP address format (dotted-quad) or as a decimal
value.
interval Specifies the stability interval in seconds. The value of interval can range
from 0 to 3600 seconds.
To Next Page
Loading...
