show license
4-4 Activating Licensed Features
show license
Use this command to display license key information for switches with activated licenses.
Syntax
show license [unit number]
Parameters
Defaults
If no unit number is specified, license key information for all switches in the stack is displayed.
Mode
Switch command, read-only.
Usage
Licenses can be displayed, applied, and cleared only with the license commands described in this
chapter. General configuration commands such as show config or clear config do not affect
licenses.
Example
This example shows how to display license key information for switch unit 1 in the stack.
C3(ro)->show license unit 1
unit 1
key: INCREMENT advrouter 2006.0728 permanent 31173CAC6495 045100039001
status: Active
clear license
Use this command to clear the license key settings..
Syntax
clear license featureId feature
Parameters
Defaults
None.
Mode
Switch command, read-write.
unit number (Optional) Specifies the switch for which to display license information.
Refer to Chapter 2, Configuring Switches in a Stack, for more
information about stack unit IDs, or numbers.
featureID feature The name of the feature being cleared.
To Next Page
Loading...
Need help?
General