set igmpsnooping interfacemode
17-4 IGMP Configuration
Example
This example shows how to enable IGMP on the system:
C3(su)->set igmpsnooping adminmode enable
set igmpsnooping interfacemode
Use this command to enable or disable IGMP on one or all ports.
Syntax
set igmpsnooping interfacemode port-string {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Usage
In order for IGMP snooping to be enabled on one or all ports, it must be globally enabled on the
device using the set igmpsnooping adminmode command as described in “set igmpsnooping
adminmode” on page 17-3, and then enabled on a port(s) using this command.
Example
This example shows how to enable IGMP on port ge.1.10:
C3(su)->set igmpsnooping interfacemode ge.1.10 enable
set igmpsnooping groupmembershipinterval
Use this command to configure the IGMP group membership interval time for the system.
Syntax
set igmpsnooping groupmembershipinterval time
Note: IGMP snooping cannot be controlled via WebView.
port-string Specifies one or more ports on which to enable or disable IGMP.
enable | disable Enables or disables IGMP.
To Next Page
Loading...
Need help?
General