telnet
3-34 Basic Configuration
Mode
Switch command, read-write.
Example
This example shows how to disable inbound and outbound Telnet services:
C3(su)->set telnet disable all
Disconnect all telnet sessions and disable now (y/n)? [n]: y
All telnet sessions have been terminated, telnet is now disabled.
telnet
Use this command to start a Telnet connection to a remote host. The Enterasys C3 switch allows a
total of four inbound and / or outbound Telnet session to run simultaneously.
Syntax
telnet host [port]
Parameters
Defaults
If not specified, the default port number 23 will be used.
Mode
Switch command, read-write.
Example
This example shows how to start a Telnet session to a host at 10.21.42.13:
C3(su)->telnet 10.21.42.13
Managing Switch Configuration and Files
Configuration Persistence Mode
The default state of configuration persistence mode is “auto,” which means that when CLI
configuration commands are entered, or when a configuration file stored on the switch is
executed, the configuration is saved to NVRAM automatically at the following intervals:
• On a standalone unit, the configuration is checked every two minutes and saved if there has
been a change.
• On a stack, the configuration is saved across the stack every 5 minutes if there has been a
change.
If you want to save a running configuration to NVRAM more often than the automatic intervals,
execute the save config command and wait for the system prompt to return. After the prompt
returns, the configuration will be persistent.
host Specifies the name or IP address of the remote host.
port (Optional) Specifies the server port number.
To Next Page
Loading...
Need help?
General