Enterasys C3G124-24 - Show Dhcpsnooping Binding

show dhcpsnooping binding
Enterasys C3 Configuration Guide 23-11
Example
This example shows the output of the show dhcpsnooping port command.
C3(su)->show dhcpsnooping port ge.1.1
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
---------- ------------- ------------- ---------------
ge.1.1 No 20 2
show dhcpsnooping binding
Use this command to display the contents of the DHCP snooping bindings database.
Syntax
show dhcpsnooping binding [dynamic | static] [port port-string] [vlan vlan-id]
Parameters
Defaults
If no parameters are entered, all bindings in the database are displayed.
Mode
Switch command, read-write.
Usage
This command displays information about the DHCP bindings in the DHCP snooping database.
Example
This example shows the output of the show dhcpsnooping binding command when no
parameters are entered.
C3(su)->show dhcpsnooping binding
Total number of bindings: 2
MAC Address IP Address VLAN Interface Type Lease (min)
----------------- --------------- ---- ----------- ------- -----------
00:02:B3:06:60:80 192.168.10.10 3 ge.1.1 STATIC
00:0F:FE:00:13:04 192.168.20.1 5 ge.1.30 DYNAMIC 1440
dynamic | static (Optional) Limits the display of bindings in the database by type of
entry, either dynamic or static.
port port-string (Optional) Limits the display of bindings in the database by port.
vlan vlan-id (Optional) Limits the display of bindings in the database by VLAN id.