set inlinepower threshold
8-2 Configuring System Power and PoE
Mode
Switch command, read-only.
Example
This example shows how to display system power properties:
C3(su)->show inlinepower
Detection Mode : auto
Unit Status Power(W) Consumption(W) Usage(%) Threshold(%) Trap
---- ------ ------- ------------- -------- ------------ ----
1 auto 375 0.00 0.00 80 enable
Table 8-1 provides an explanation of the command output.
set inlinepower threshold
Use this command to set the power usage threshold on a specified unit or module.
Syntax
set inlinepower threshold usage-threshold module-number
Parameters
Defaults
None.
Mode
Switch command, read-write.
Table 8-1 show inlinepower Output Details
Output What It Displays...
Detection Mode Displays the PD detection mode used by the switch. The detection mode can be
configured with the command “set inlinepower detectionmode” (page 8-3).
Unit Number of PoE-capable module.
Status Whether the PoE administrative state is off (disabled) or auto (on). This state is not
configurable.
Power (W) Unit’s available power wattage.
Consumption (W) Unit’s power wattage consumed.
Usage (%) Unit’s percentage of total system PoE power usage.
Threshold (%) Unit’s alloted percentage of total PoE power available in the system. The threshold
can be configured with the command “set inlinepower threshold” (page 8-2).
Trap Whether PoE trap messaging is enabled or disabled on this unit. Trap messaging
can be configured with the command “set inlinepower trap” (page 8-3).
usage-threshold Specifies a power threshold as a percentage of available system power.
Valid values are 11 to 100.
module-number Specifies the module or unit on which to set the power threshold.
To Next Page
Loading...
Need help?
General