Enterasys C3G124-24 - Set Snmp Access

set snmp access
Enterasys C3 Configuration Guide 12-17
set snmp access
Use this command to set an SNMP access configuration.
Syntax
set snmp access groupname security-model {v1 | v2c | usm} [noauthentication |
authentication | privacy] [context context] [exact | prefix] [read read] [write
write] [notify notify] [volatile | nonvolatile]
Parameters
Defaults
If security level is not specified, no authentication will be applied.
If context is not specified, access will be enabled for the default context. If context is specified
without a context match, exact match will be applied.
If read view is not specified none will be applied.
If write view is not specified, none will be applied.
If notify view is not specified, none will be applied.
If storage type is not specified, entries will be stored as permanent and will be held through device
reboot.
Storage type Whether access entries for this group are stored in volatile, nonvolatile
or read-only memory.
Row status Status of this entry: active, notInService, or notReady.
Table 12-5 show snmp access Output Details (Continued)
Output Field What It Displays...
groupname Specifies a name for an SNMPv3 group.
security-model v1 |
v2c | usm
Specifies SNMP version 1, 2c or 3 (usm).
noauthentication |
authentication |
privacy
(Optional) Applies SNMP security level as no authentication,
authentication (without privacy) or privacy. Privacy specifies that
messages sent on behalf of the user are protected from disclosure.
context context exact
| prefix
(Optional) Sets the context for this access configuration and specifies that
the match must be exact (matching the whole context string) or a prefix
match only. Context is a subset of management information this SNMP
group will be allowed to access. Valid values are full or partial context
names. To review all contexts configured for the device, use the show
snmp context command as described in “show snmp context” on
page 12-20.
read read (Optional) Specifies a read access view.
write write (Optional) Specifies a write access view.
notify notify (Optional) Specifies a notify access view.
volatile |
nonvolatile | read-
only
(Optional) Stores associated SNMP entries as temporary or permanent, or
read-only.