show ipv6 route preferences
29-26 IPv6 Configuration
ON1 - OSPF NSSA Ext Type 1, ON2 - OSPF NSSA Ext Type 2
S ::/0 [1/0]
via FE80::2D0:B7FF:FE2C:7694, Vlan 6
C 3FFE:501:FFFF:100::/64 [0/0]
via ::, Vlan 6
C 3FFE:501:FFFF:101::/64 [0/0]
via ::, Vlan 7
C 3FFE:501:FFFF:108::/64 [0/0]
via ::, Vlan 6
S 3FFE:501:FFFF:109::/64 [1/0]
via 3FFE:501:FFFF:100:200:FF:FE00:A1A1, Vlan 6
via FE80::200:FF:FE00:A1A1, Vlan 6
Table 29-2 provides an explanation of the command output.
show ipv6 route preferences
This command shows the preference value associated with the type of route.
Syntax
show ipv6 route preference
Parameters
None.
Defaults
None.
Mode
Router privileged execution: C3(su)->router#
Router user execution: C3(su)->router>
Table 29-2 show ipv6 route Output Details
Output Field What It Displays...
Codes: Key for the routing protocol codes that might appear in the Codes
column of the routing table output.
Codes column The code for the routing protocol that created this routing entry.
IPv6 prefix/prefix-length The IPv6 prefix and prefix length of the destination IPv6 network
corresponding to this route.
[ Preference / Metric ] The administrative distance (preference) and cost (metric)
associated with this route.
Tag The decimal value of the tag associated with a redistributed route,
if it is not 0.
via Next-hop The outgoing router IPv6 address to use when forwarding traffic to
the next router, if any, in the path toward the destination.
Interface The outgoing router interface to use when forwarding traffic to the
next destination.
To Next Page
Loading...
Need help?
General