set system name
3-22 Basic Configuration
set system name
Use this command to configure a name for the system.
Syntax
set system name [string]
Parameters
Defaults
If string is not specified, the system name will be cleared.
Mode
Switch command, read-write.
Example
This example shows how to set the system name to Information Systems:
C3(su)->set system name “Information Systems”
set system location
Use this command to identify the location of the system.
Syntax
set system location [string]
Parameters
Serial # Serial number of the switch.
Versions • Hw: Hardware version number.
• Bp: BootPROM version.
• Fw: Current firmware version number.
• BuFw: Backup firmware version number.
• PoE: Power over Ethernet driver version. (Displays only for PoE switches.)
Table 3-4 show version Output Details (Continued)
Output Field What It Displays...
string (Optional) Specifies a text string that identifies the system.
Note: A name string containing a space in the text must be enclosed in quotes as
shown in the example below.
string (Optional) Specifies a text string that indicates where the system is
located.
Note: A location string containing a space in the text must be enclosed in quotes
as shown in the example below.
To Next Page
Loading...
Need help?
General