set spantree msti
Enterasys C3 Configuration Guide 13-13
Mode
Switch command, read-only.
Example
This example shows how to display a list of MST instances. In this case, SID 2 has been configured:
C3(su)->show spantree mstilist
Configured Multiple Spanning Tree instances:
2
set spantree msti
Use this command to create or delete a Multiple Spanning Tree instance.
Syntax
set spantree msti sid sid {create | delete}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to create an MST instance 2:
C3(su)->set spantree msti sid 2 create
clear spantree msti
Use this command to delete one or more Multiple Spanning Tree instances.
Syntax
clear spantree msti [sid sid]
Parameters
Defaults
If sid is not specified, all MST instances will be cleared.
sid sid Sets the Multiple Spanning Tree ID. Valid values are 1 - 4094.
Enterasys C3 devices will support up to 4 MST instances, in addition to
SID0.
create | delete Creates or deletes an MST instance.
sid sid (Optional) Deletes a specific multiple Spanning Tree ID.
To Next Page
Loading...
