Configuring Spanning Tree Port Parameters
Enterasys C3 Configuration Guide 13-37
Configuring Spanning Tree Port Parameters
Purpose
To display and set Spanning Tree port parameters.
Commands
set spantree portadmin
Use this command to disable or enable the Spanning Tree algorithm on one or more ports.
Syntax
set spantree portadmin port-string {disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read-write.
For information about... Refer to page...
set spantree portadmin 13-37
clear spantree portadmin 13-38
show spantree portadmin 13-38
show spantree portpri 13-39
set spantree portpri 13-39
clear spantree portpri 13-40
show spantree adminpathcost 13-41
set spantree adminpathcost 13-41
clear spantree adminpathcost 13-42
show spantree adminedge 13-42
set spantree adminedge 13-42
clear spantree adminedge 13-43
show spantree operedge 13-44
port-string Specifies the port(s) for which to enable or disable Spanning Tree. For a
detailed description of possible port-string values, refer to “Port String
Syntax Used in the CLI” on page 11-1.
disable | enable Disables or enables Spanning Tree.
To Next Page
Loading...
