set lldp tx-interval
Enterasys C3 Configuration Guide 10-23
Defaults
If port-string is not specified, only non-default values will be displayed for all ports that have non-
default values configured.
If a port-string is specified, then all values, default and non-default, are displayed for the specified
ports.
Mode
Switch command, read-only.
Example
This example shows how to display all LLDP network policy information for ge.1.1.
C3(ro)->show lldp port network-policy all ge.1.1
Ports Application State Tag Vlan-Id Cos Dscp
------- --------------------- -------- -------- ------- --- ---
ge.1.1 voice enabled untagged 1 0 0
voice signaling enabled untagged 1 0 0
guest voice enabled untagged 1 0 0
guest voice signaling enabled untagged 1 0 0
softphone voice enabled untagged 1 0 0
video conferencing enabled untagged 1 0 0
streaming video enabled untagged 1 0 0
video signaling enabled untagged 1 0 0
set lldp tx-interval
Use this command to set the time, in seconds, between successive LLDP frame transmissions
initiated by changes in the LLDP local system information.
Syntax
set lldp tx-interval frequency
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example sets the transmit interval to 20 seconds.
port-string (Optional) Displays information about LLDP network policy for
one or a range of ports.
frequency Specifies the number of seconds between transmissions of LLDP
frames. Value can range from 5 to 32,768 seconds. The default is 30
seconds.
To Next Page
Loading...
Need help?
General