Enterasys C3G124-24 - Set Spantree Adminpathcost; Show Spantree Adminpathcost

show spantree adminpathcost
Enterasys C3 Configuration Guide 13-41
show spantree adminpathcost
Use this command to display the admin path cost for a port on one or more Spanning Trees.
Syntax
show spantree adminpathcost [port port-string] [sid sid]
Parameters
Defaults
If port-string is not specified, admin path cost for all Spanning Tree ports will be displayed.
If sid is not specified, admin path cost for Spanning Tree 0 will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display the admin path cost for ge.3.4 on SID 1:
C3(su)->show spantree adminpathcost port ge.3.4 sid 1
Port
ge.3.4 has a Port Admin Path Cost of 0 on SID 1
set spantree adminpathcost
Use this command to set the administrative path cost on a port and one or more Spanning Trees.
Syntax
set spantree adminpathcost port-string cost [sid sid]
Parameters
Defaults
If sid is not specified, admin path cost will be set for Spanning Tree 0.
Mode
Switch command, read-write.
port port-string (Optional) Displays the admin path cost value for specific port(s). For a
detailed description of possible port-string values, refer to “Port String
Syntax Used in the CLI” on page 11-1.
sid sid (Optional) Displays the admin path cost for a specific Spanning Tree
identifier. Valid values are 0 - 4094. If not specified, SID 0 will be assumed.
port-string Specifies the port(s) on which to set an admin path cost. For a detailed
description of possible port-string values, refer to “Port String Syntax Used
in the CLI” on page 11-1.
cost Specifies the port path cost. Va1id values are 0 - 200000000.
sid sid (Optional) Sets the admin path cost for a specific Spanning Tree identifier.
Valid values are 0 - 4094. If not specified, SID 0 will be assumed.