clear lacp groups
Enterasys C3 Configuration Guide 11-59
Usage
The maximum number of physical ports that can be assigned to LAGs is 48 ports. If 6 groups are
configured, the maximum number of physical ports per LAG is 8. For 12 groups, the maximum
number of ports per LAG is 4, and for 24 groups, the maximum number of ports per LAG is 2.
Changing the group limit will result in a system reset and LACP configuration settings will be
returned to their default values, with the exception of the group limit.
Example
This example sets the number of LAG groups to 24.
C3(su)->set lacp groups 24
Changing group limits will result in a system reset and loss of LACP configuration.
Do you wish to proceed? (y/n)
clear lacp groups
Use this command to reset the maximum number of LACP groups to the default of 6.
Syntax
clear lacp groups
Parameters
None.
Defaults
The default maximum number of groups supported is 6.
Mode
Switch command, read-write.
Usage
If the number of LACP groups has been changed from the default, executing this command will
result in a system reset and LACP configuration settings will be returned to their default values,
including the group limit.
Example
This example resets the group limit to the default of 6.
C3(su)->clear lacp groups
Changing group limits will result in a system reset and loss of LACP configuration.
Do you wish to proceed? (y/n)
show lacp groups
Use this command to display the maximum number of LACP groups configured on the switch.
Syntax
show lacp groups
To Next Page
Loading...
Need help?
General