ping ipv6 interface
Enterasys C3 Configuration Guide 29-7
Parameters
Defaults
None.
Mode
Router privileged exec: C3(su)->router#
Router user exec: C3(su)->router>
Usage
Use this command to determine whether another computer is on the network. To use this
command, configure the switch for network (in-band) connection. The source and target devices
must have the ping utility enabled and running on top of TCP/IP.
The switch can be pinged from any IP workstation with which the switch is connected through the
default VLAN (VLAN 1), as long as there is a physical path between the switch and the
workstation. The terminal interface sends three pings to the target station.
Examples
This example shows output from a successful ping to IPv6 address 2001:0db8:1234:5555::1234:1.
C3(su)->router#ping ipv6 2001:0db8:1234:5555::1234:1
Send count=3, Receive count=3 from 2001:DB8:1234:5555::1234:1
Average round trip time = 1.00 ms
This example shows output from an unsuccessful ping to IPv6 address
2001:0db8:1234:5555::1234:1.
C3(su)->ping ipv6 2001:0db8:1234:5555::1234:1
no answer from 2001:DB8:1234:5555::1234:1
ping ipv6 interface
Use this command to test routing network connectivity by sending IP ping requests.
Syntax
ping ipv6 interface {vlan vlan-id | tunnel tunnel-id | loopback loop-id}
{link-local-address ipv6-lladdr | ipv6-addr} [size num]
Parameters
ipv6-addr Specifies the global IPv6 address of the system to ping. Enter the address in
the form documented in RFC 4291, with the address specified in
hexadecimal using 16-bit values between colons.
size num (Optional) Specifies the size of the datagram packet. The value of num can
range from 48 to 2048 bytes.
vlan vlan-id Specifies a VLAN interface as the source.
tunnel tunnel-id Specifies a tunnel interface as the source.
loopback loop-id Specifies a loopback interface as the source.
link-local-address
ipv6-lladdr
Specifies a link-local IPv6 address to ping.
To Next Page
Loading...
Need help?
General