Enterasys C3G124-24 - Traceroute

traceroute
25-22 IP Configuration
Defaults
None.
Mode
Privileged EXEC: C3(su)->router#
Usage
This command is also available in switch mode.
Examples
This example shows output from a successful ping to IP address 182.127.63.23:
C3(su)->router#ping 182.127.63.23
182.127.63.23 is alive
This example shows output from an unsuccessful ping to IP address 182.127.63.24:
C3(su)->router#ping 182.127.63.24
no answer from 182.127.63.24
traceroute
Use this command to display a hop-by-hop path through an IP network from the device to a
specific destination host. Three ICMP probes will be transmitted for each hop between the source
and the traceroute destination.
Syntax
traceroute host
Parameters
Defaults
None.
Mode
Privileged EXEC: C3(su)->router#
Usage
There is also a traceroute command available in switch mode.
Example
This example shows how to use traceroute to display a round trip path to host 192.141.90.183.
C3(su)->router#traceroute 192.141.90.183
Traceroute to 192.141.90.183, 30 hops max, 40 byte packets
1 10.1.56.1 0.000 ms 0.000 ms 0.000 ms
2 10.1.48.254 10.000 ms 0.000 ms 0.000 ms
3 10.1.0.2 0.000 ms 0.000 ms 0.000 ms
4 192.141.89.17 0.000 ms 0.000 ms 10.000 ms
5 192.141.100.13 0.000 ms 10.000 ms 0.000 ms
host Specifies a host to which the route of an IP packet will be traced.