clear maclock static
32-68 Authentication and Authorization Configuration
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to set the maximum number of allowable static MACs to 2 on ge.3.1:
C3(rw)->set maclock static ge.3.1 2
clear maclock static
Use this command to reset the number of static MAC addresses allowed per port to the default
value of 20.
Syntax
clear maclock static port-string
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to reset the number of allowable static MACs on ge.2.3:
C3(rw)->clear maclock static ge.2.3
set maclock firstarrival
Use this command to restrict MAC locking on a port to a maximum number of end station
addresses first connected to that port.
Syntax
set maclock firstarrival port-string value
port-string Specifies the port on which to reset number of static MAC addresses
allowed. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 11-1.
To Next Page
Loading...
