Enterasys C3G124-24 User Manual

set logout
Enterasys C3 Configuration Guide 3-25
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display the CLI logout setting:
C3(su)->show logout
Logout currently set to: 10 minutes.
set logout
Use this command to set the time (in minutes) an idle console or Telnet CLI session will remain
connected before timing out.
Syntax
set logout timeout
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to set the system timeout to 10 minutes:
C3(su)->set logout 10
show console
Use this command to display console settings.
Syntax
show console [baud] [bits] [flowcontrol] [parity] [stopbits] [vt100]
Parameters
timeout Sets the number of minutes the system will remain idle before timing out.
baud (Optional) Displays the input/output baud rate.
bits (Optional) Displays the number of bits per character.

Enterasys C3G124-24 Specifications

General

Brand	Enterasys
Model	C3G124-24
Category	Switch
Language	English