Enterasys C3G124-24 - Set Lldp Port Trap; Set Lldp Port Med-Trap

set lldp port trap
10-26 Discovery Protocol Configuration
Defaults
None.
Mode
Switch command, read-write.
Example
This example enables both transmitting LLDPDUs and receiving and processing LLDPDUs from
remote systems on ports ge.1.1 through ge.1.6.
C3(rw)->set lldp port status both ge.1.1-6
set lldp port trap
Use this command to enable or disable sending LLDP notifications (traps) when a remote system
change is detected.
Syntax
set lldp port trap {enable | disable} port-string
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example enables transmitting LLDP traps on ports ge.1.1 through ge.1.6.
C3(rw)->set lldp port trap enable ge.1.1-6
set lldp port med-trap
Use this command to enable or disable sending an LLDP-MED notification when a change in the
topology has been sensed on the port (that is, a remote endpoint device has been attached or
removed from the port).
Syntax
set lldp port med-trap {enable | disable} port-string
port-string Specifies the port or range of ports to be affected.
enable Enable transmitting LLDP traps on the specified ports.
disable Disable transmitting LLDP traps on the specified ports.
port-string Specifies the port or range of ports to be affected.