Commands Configuring System Logging
Enterasys C3 Configuration Guide 19-3
Commands
show logging server
Use this command to display the Syslog configuration for a particular server.
Syntax
show logging server [index]
Parameters
Defaults
If index is not specified, all Syslog server information will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display Syslog server configuration information:
C3(ro)->show logging server
For information about... Refer to page...
show logging server 19-3
set logging server 19-4
clear logging server 19-5
show logging default 19-6
set logging default 19-6
clear logging default 19-7
show logging application 19-7
set logging application 19-9
clear logging application 19-10
show logging local 19-11
set logging local 19-11
clear logging local 19-12
show logging buffer 19-13
show logging interface 19-13
set logging interface 19-14
clear logging interface 19-15
index (Optional) Displays Syslog information pertaining to a specific server
table entry. Valid values are 1-8.
To Next Page
Loading...
