show ipv6 ospf asbr
31-34 OSPFv3 Configuration
show ipv6 ospf asbr
This command displays OSPFv3 routes to reach AS border routers.
Syntax
show ipv6 ospf asbr
Parameters
None.
Defaults
None.
Mode
Router privileged execution: C3(su)->router#
Example
This example shows how to display OSPFv3 AS border router routes.
C3(su)->router# show ipv6 ospf asbr
Type Router Id Cost Area ID Next Hop Next Hop
Intf
----- -------------- ---- ------------ -------------------------------- --------
INTER 1.11.1.1 5 0.0.0.20 FE80::100:1111:FEE6:FB7A Vlan 35
Table 31-4 provides an explanation of the command output.
Next Hop Intf Address of the next hop toward the destination.
Next Hop Intf The outgoing router interface to use when forwarding traffic to the
next hop.
Table 31-3 show ipv6 ospf abr Output Details (Continued)
Output Field What It Displays...
Table 31-4 show ipv6 ospf asbr Output Details
Output Field What It Displays...
Type The type of the route to the destination, which is one of the
following values:
INTRA — Intra-area route
INTER — Inter-area route
Router ID Router ID of the destination.
Cost Cost of using this route.
Area ID The area ID of the area from which this route is learned.
Next Hop Address of the next hop toward the destination.
Next Hop Intf The outgoing router interface to use when forwarding traffic to the
next hop.
To Next Page
Loading...
