clear gvrp
14-24 802.1Q VLAN Configuration
Mode
Switch command, read-write.
Examples
This example shows how to enable GVRP globally on the device:
C3(su)->set gvrp enable
This example shows how to disable GVRP globally on the device:
C3(su)->set gvrp disable
This example shows how to enable GVRP on ge.1.3:
C3(su)->set gvrp enable ge.1.3
clear gvrp
Use this command to clear GVRP status on one or more ports.
Syntax
clear gvrp [port-string]
Parameters
Defaults
If port-string is not specified, GVRP status will be cleared to the default condition for all ports.
Mode
Switch command, read-write.
Usage
This command does not affect the global state of GVRP. To enable or disable GVRP globally, use
the set gvrp enable | disable command.
Example
This example shows how to clear GVRP status on all ports on the device:
C3(su)->clear gvrp
set garp timer
Use this command to adjust the values of the join, leave, and leaveall timers.
Syntax
set garp timer {[join timer-value] [leave timer-value] [leaveall timer-value]}
port-string
port-string (Optional) Clears GVRP status on specific port(s). For a detailed description of
possible port-string values, refer to “Port String Syntax Used in the CLI” on
page 11-1.
To Next Page
Loading...
