set maclock disable-port
32-74 Authentication and Authorization Configuration
Defaults
Syslog messages are disabled by default. When a set maclock syslock enable command is
executed without the threshold or violation parameter, violation is assumed.
Mode
Switch mode, read-write.
Usage
When violation is enabled, this feature authorizes the switch to send a syslog message if an end
station is connected that exceeds the maximum values configured using the set maclock
firstarrival and set maclock static commands. Violating MAC addresses are dropped from the
device’s (or stack’s) filtering database.
When threshold is enabled, the agent issues a syslog message when the MAC address table
threshold, as defined in the etsysMACLockingFirstArrivalStationsAllocated object, is reached.
Example
This example enables the MAC lock syslog threshold message on ge.2.3.
C3(su)->set maclock syslog ge.2.3 enable threshold
set maclock disable-port
Use this command to set MAC locking threshold shutdown (corresponds to
etsMACLockingThresholdShutdown).
Syntax
set maclock disable-port port-string
Parameters
Defaults
MAC lock threshold shutdown is disabled on all ports by default.
Mode
Switch command, read-write.
Usage
When threshold shutdown is enabled, the agent attempts to disable a port (operstatus down)
when the MAC address table threshold, as defined in etsysMACLockingFirstArrivalStations-
Allocated object, is exceeded.
Example
This example enables MAC lock disable-port on ge.2.3.
C3(su)->set maclock disable-port ge.2.3
port-string Specifies the port or ports on which MAC lock threshold shutdown will
be enabled.
To Next Page
Loading...
Need help?
General