Enterasys C3G124-24 - Clearing and Closing the CLI; Purpose; Commands; Cls (Clear Screen)

Clearing and Closing the CLI
Enterasys C3 Configuration Guide 3-45
Mode
Switch command, read-write.
Example
This example shows how to clear the retry value to the default of 5 retries.
C3(rw)-> clear tftp retry
Clearing and Closing the CLI
Purpose
To clear the CLI screen or to close your CLI session.
Commands
cls (clear screen)
Use this command to clear the screen for the current CLI session.
Syntax
cls
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to clear the CLI screen:
C3(su)->cls
For information about... Refer to page...
cls 3-45
exit 3-46