ipv6 nd suppress-ra
Enterasys C3 Configuration Guide 29-19
Usage
The no form of this command resets the lifetime value to the default of 1800 seconds.
Example
This example sets the router advertisement lifetime value to 3600 seconds.
C3(su)->router(Config-if(Vlan 1))# ipv6 nd ra-lifetime 3600
ipv6 nd suppress-ra
This command suppresses Router Advertisement transmission on this interface.
Syntax
ipv6 nd suppress-ra
no ipv6 nd suppress-ra
Parameters
None.
Defaults
Suppression disabled. That is, Router Advertisements are sent by default.
Mode
Router interface configuration: C3(su)->router(Config-if(Vlan 1))#
Usage
By default, transmission of router advertisements is enabled. This command disables such
transmissions. Use the no form of this command to re-enable transmission.
Example
This example disables router advertisement transmission.
C3(su)->router(Config-if(Vlan 1))# ipv6 nd suppress-ra
ipv6 nd prefix
This command configures the IPv6 prefixes to be included in router advertisements sent by this
interface.
Syntax
ipv6 nd prefix {ipv6-prefix/prefix-length} [{valid-lifetime | infinite}
{preferred-lifetime | infinite}] [no-autoconfig] [off-link]
no ipv6 nd prefix {ipv6-prefix/prefix-length}
To Next Page
Loading...
Need help?
General