Enterasys C3G124-24 - Clear Spantree Debug

clear spantree debug
Enterasys C3 Configuration Guide 13-35
Usage
This command displays diagnostic information from the Enterasys Spanning Tree Diagnostic MIB.
Example
This example displays counters for Link Aggregation port lag.0.1.
C3(su)->show spantree debug port lag.0.1
STP Diagnostic Common Counters
----------------------------------
Topology Change Count - 0
Message Expiration Count - 0
Invalid BPDU Count - 0
STP BPDU Rx Count - 0
STP BPDU Tx Count - 0
STP TCN BPDU Rx Count - 0
STP TCN BPDU Tx Count - 0
STP TC BPDU Rx Count - 0
STP TC BPDU Tx Count - 0
RST BPDU Rx Count - 0
RST BPDU Tx Count - 0
RST TC BPDU Rx Count - 0
RST TC BPDU Tx Count - 0
MST BPDU Rx Count - 0
MST BPDU Tx Count - 177752
MST CIST TC BPDU Rx Count - 0
MST CIST TC BPDU Tx Count - 0
STP Diagnostic Port Counters for Interface Number lag.0.1
---------------------------------------------------------
Port Role - Disabled
Message Expiration Count - 0
Invalid BPDU Count - 0
STP BPDU Rx Count - 0
STP BPDU Tx Count - 0
STP TCN BPDU Rx Count - 0
STP TCN BPDU Tx Count - 0
STP TC BPDU Rx Count - 0
STP TC BPDU Tx Count - 0
RST BPDU Rx Count - 0
RST BPDU Tx Count - 0
RST TC BPDU Rx Count - 0
RST TC BPDU Tx Count - 0
MST BPDU Rx Count - 0
MST BPDU Tx Count - 0
MST CIST TC BPDU Rx Count - 0
MST CIST TC BPDU Tx Count - 0
clear spantree debug
Use this command to clear Spanning Tree debug counters.
Syntax
clear spantree debug
Parameters
None.