Enterasys C3G124-24 - Set Port Protected Name; Show Port Protected Name

set port protected name
Enterasys C3 Configuration Guide 11-63
Mode
Switch command, read-write.
Example
This example shows how to clear protected ports ge.1.1 through ge.1.3:
C3(rw)->clear port protected ge.1.1-3
set port protected name
Use this command to assign a name to a protected port group id.
Syntax
set port protected name group-id name
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to assign the name “group1” to protected port group 1:
C3(rw)->set port protected name 1 group1
show port protected name
Use this command to display the name for the group ids specified.
Syntax
show port protected name group-id
Parameters
Defaults
None.
Mode
Read-only.
group-id Specifies the id of this group. Id can range from 0 to 2.
name Specifies a name for the group. The name can be up to 32 characters in
length.
group-id Specifies the id of the group to display. Id can range from 0 to 2.