Enterasys C3G124-24 - Set Mgmt-Auth-Notify

set mgmt-auth-notify
6-2 Management Authentication Notification MIB Commands
C3(su)->show mgmt-auth-notify
Management Type Status
--------------- --------
console Enabled
ssh Enabled
telnet Enabled
webview Enabled
inactiveUser Enabled
maxUserAttempt Enabled
maxUserFail Enabled
set mgmt-auth-notify
Use this command to enable or disable notifications for the authentication notification types
specified in the Enterasys Management Authentication Notification MIB.
Syntax
set mgmt-auth-notify {enable | disable} [console] [ssh] [telnet] [webview]
[inactiveUser] [maxUserAttempt] [maxUserFail]
Parameters
Defaults
If none of the optional Management Authentication access types are entered, then authentication
notifications for all authentications types listed above will either be enabled or disabled.
Mode
Switch command, read-write.
Usage
You can specifically enable or disable a single authentication notification type, multiple
authentication notification types or all the authentication notification types. The default setting is
that all Management Authentication Notification types are enabled for authentication notifcations.
enable Enables selected or all notification types.
disable Disables selected or all notification types.
console (Optional) console authentications.
ssh (Optional) SSH authentications.
telnet (Optional) TELNET authentications.
webview (Optional) Webview connection authentications.
inactiveUser (Optional) Username unused for specified interval.
maxUserAttempt (Optional) A user has attempted to simultaneously access the device too
many times (console/telnet/SSH).
maxUserFail (Optional) A user has entered too many bad passwords.