Enterasys C3G124-24 - Set Tacacs; Show Tacacs Server

set tacacs
Enterasys C3 Configuration Guide 36-3
set tacacs
Use this command to enable or disable the TACACS+ client.
Syntax
set tacacs {enable | disable}
Parameters
Defaults
None.
Mode
Switch command, Read-Write.
Usage
The TACACS+ client can be enabled on the switch anytime, with or without a TACACS+ server
online. If the TACACS+ server is offline and TACACS+ is enabled, the login authentication is
switched to RADIUS or local, if enabled.
Examples
This example shows how to enable the TACACS+ client.
C3(rw)->set tacacs enable
show tacacs server
Use this command to display the current TACACS+ server configuration.
Syntax
show tacacs server {index | all}
TACACS+ singleconnect state Whether TACACS+ singleconnect is enabled or disabled.
When enabled, the TACACS+ client sends multiple requests over a
single TCP connection.
TACACS+ service The name of the service that is requested by the TACACS+ client for
session authorization. “exec” is the default service name.
TACACS+ session authorization
A-V pairs
Displays the attribute – value pairs that are mapped to the read-only,
read-write, and super-user access privilege levels for the service
requested for session authorization.
The attribute names and values shown in the example above are the
default values.
TACACS+ Server Displays the TACACS+ server information used by the TACACS+
client.
Table 36-1 show tacacs Output Details (Continued)
Output... What it displays...
enable | disable Enables or disables the TACACS client.