Enterasys C3G124-24 - Show Ipv6 Neighbors; Show Ipv6 Netstat

show ipv6 neighbors
Enterasys C3 Configuration Guide 28-7
show ipv6 neighbors
Use this command to display the system IPv6 Neighbor Discovery Protocol cache.
Syntax
show ipv6 neighbors
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows example output of this command.
C3(su)->show ipv6 neighbors
Last
IPv6 Address MAC Address isRtr State Updated
--------------------------------------- ----------------- ----- ------- -------
2001:db8:1234:6666::2310:3 00:04:76:73:42:31 True Reachable 00:01:16
show ipv6 netstat
Use this command to display IPv6 netstat information.
Syntax
show ipv6 netstat
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Usage
The network connection information displayed by this command can be used to find problems in
the network.
Example
This example shows the output of this command. Table 28-1 describes the output of this
command.