set ciscodp status
Enterasys C3 Configuration Guide 10-9
set ciscodp status
Use this command to enable or disable the Cisco discovery protocol globally on the switch.
Syntax
set ciscodp state {auto | disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to globally enable CiscoDP:
C3(su)->set ciscodp state enable
set ciscodp timer
Use this command to set the number of seconds between Cisco discovery protocol PDU
transmissions.
Syntax
set ciscodp timer seconds
Table 10-3 show ciscodp port info Output Details
Output Field What It Displays...
Port Port designation. For a detailed description of possible port-string values, refer to
“Port String Syntax Used in the CLI” on page 11-1.
State Whether Cisco DP is enabled, disabled or auto-enabled on the port. Default state of
enabled can be changed using the set ciscodp port command.
vvid Whether a voice VLAN ID has been set on this port. Default of none can be changed
using the set ciscodp port command.
trusted The trust mode of the port. Default of trusted can be changed using the set ciscodp
port command.
cos The Class of Service priority value for untrusted traffic. The default of 0 can be
changed using the set ciscodp port command.
auto Globally enable only if Cisco DP PDUs are received.
disable Globally disable Cisco discovery protocol.
enable Globally enable Cisco discovery protocol.
To Next Page
Loading...
Need help?
General