Enterasys C3G124-24 - Clear Port Jumbo; Set Port Jumbo

set port jumbo
11-14 Port Configuration
set port jumbo
Use this command to enable or disable jumbo frame support on one or more ports.
Syntax
set port jumbo {enable | disable}[port-string]
Parameters
Defaults
If port-string is not specified, jumbo frame support will be enabled or disabled on all ports.
Mode
Switch command, read-write.
Example
This example shows how to enable jumbo frame support for Ethernet port 14 in unit 3:
C3(su)->set port jumbo enable ge.3.14
clear port jumbo
Use this command to reset jumbo frame support status to enabled on one or more ports.
Syntax
clear port jumbo [port-string]
Parameters
Defaults
If port-string is not specified, jumbo frame support status will be reset on all ports.
Mode
Switch command, read-write.
Example
This example shows how to reset jumbo frame support status for Ethernet port 14 in unit 3:
C3(su)->clear port jumbo ge.3.14
enable | disable Enables or disables jumbo frame support.
port-string (Optional) Specifies the port(s) on which to disable or enable jumbo
frame support. For a detailed description of possible port-string values,
refer to “Port String Syntax Used in the CLI” on page 11-1.
port-string (Optional) Specifies the port(s) on which to reset jumbo frame
support status to enabled. For a detailed description of possible
port-string values, refer to “Port String Syntax Used in the CLI” on
page 11-1.