set sflow receiver port
Enterasys C3 Configuration Guide 37-9
Example
This example sets the maximum datagram size to 2800 bytes for index entry 1.
C3(su)->set sflow receiver 1 maxdatagram 2800
set sflow receiver port
Use this command to configure the UDP port on the sFlow Controller to which the switch will
send sample datagrams.
Syntax
set sflow receiver index port port
Parameters
Defaults
The default port value is 6343.
Mode
Switch command, read-write.
Example
This example changes the sFlow receiver port on the Collector to 1234.
C3(su)->set sflow receiver 1 port 1234
clear sflow receiver
Use this command to delete a receiver/Collector from the sFlow Receivers Table, or to return
certain parameters to their default values for the specified Collector.
Syntax
clear sflow receiver index [ip | maxdatagram | owner [timeout] | port]
Parameters
index Index number in the sFlow Receivers Table for the receiver/Collector
being configured. The index can range from 1 to 8.
port port Specifies the UDP port on the receiver/Collector to which the sample
datagrams should be sent. By default, the port is 6343.
index Index number in the sFlow Receivers Table for the receiver/Collector
being configured. The index can range from 1 to 8.
ip (Optional) Clear the IP address.
maxdatagram (Optional) Return the maximum datagram size to 1400 bytes.
owner (Optional) Clear the owner identity string. Entries in the sFlow Receiver
Table without an identity string are considered unclaimed.
timeout (Optional) Clear the timeout value of the specified entry.
To Next Page
Loading...
Need help?
General