Enterasys C3G124-24 - Clear Ip Address; Show Ip Protocol

clear ip address
Enterasys C3 Configuration Guide 3-5
clear ip address
Use this command to clear the system IP address.
Syntax
clear ip address
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example shows how to clear the system IP address:
C3(rw)->clear ip address
show ip protocol
Use this command to display the method used to acquire a network IP address for switch
management.
Syntax
show ip protocol
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display the method used to acquire a network IP address:
C3(su)->show ip protocol
System IP address acquisition method: dhcp