create
27-30 IPv4 Advanced Routing Protocol Configuration
Mode
Global configuration: C3(su)->router(Config)#
Usage
You must execute the router vrrp command to enable the protocol before completing other
VRRP-specific configuration tasks. For details on enabling configuration modes, refer to Table 24-2
on page 24-2.
Example
This example shows how enable VRRP configuration mode:
C3(su)->router#configure
C3(su)->router(Config)#router vrrp
C3(su)->router(Config-router)#
create
Use this command to create a VRRP session. Each Enterasys C3 system supports up to 20 VRRP
sessions. The no form of this command disables the VRRP session.
Syntax
create vlan vlan-id vrid
no create vlan vlan-id vrid
Parameters
Defaults
None.
Mode
Router configuration: C3(su)->router(Config-router)#
Usage
This command must be executed to create an instance of VRRP on a routing interface (VLAN)
before any other VRRP settings can be configured.
Example
This example shows how to create a VRRP session on the VLAN 1 interface with a VRID of 1:
C3(su)->router(Config)#router vrrp
C3(su)->router(Config-router)#create vlan 1 1
vlan vlan-id Specifies the number of the VLAN on which to create a VRRP session. This
VLAN must be configured for IP routing as described in “Pre-Routing
Configuration Tasks” on page 24-1.
vrid Specifies a unique Virtual Router ID (VRID) to associate with the routing
interface.
To Next Page
Loading...
