Enterasys C3G124-24 User Manual

set port lacp
11-56 Port Configuration
Defaults
At least one parameter must be entered per port-string.
aadminstate
lacpactive |
lacptimeout |
lacpagg |
lacpsync |
lacpcollect |
lacpdist |
lacpdef |
lacpexpire
Sets the port’s actor LACP administrative state to allow for:
lacpactive - Transmitting LACP PDUs.
lacptimeout - Transmitting LACP PDUs every 1 sec.\vs 30 sec. (default).
lacpagg - Aggregation on this port.
lacpsync - Transition to synchronization state.
lacpcollect - Transition to collection state.
lacpdist - Transition to distribution state.
lacpdef - Transition to defaulted state.
lacpexpire - Transition to expired state.
aportpri aportpri Sets the port’s actor port priority. Valid values are 0 - 65535, with lower
values designating higher priority.
asyspri asyspri Sets the port’s actor system priority. The LACP implementation on the
Enterasys C3 device uses this value to determine aggregation precedence
when there are two devices competing for the same aggregator. Valid
values are 0 - 65535, with higher precedence given to lower values.
Note: Only one LACP system priority can be set on a Enterasys C3 device, using
either this command, or the set lacp asyspri command (“set lacp asyspri” on
page 11-49).
enable (Optional) Enables LACPDU processing on this port. By default, LACP is
enabled on ports.
disable (Optional) Disables LACPDU processing on this port.
padminkey
padminkey
Sets a default value to use as the port’s partner admin key. Only ports with
matching admin keys are allowed to aggregate. Valid values are 1 - 65535.
padminport
padminport
Sets a default value to use as the port’s partner admin value. Valid values
are 1 - 65535.
padminportpri
padminportpri
Sets a default value to use as the port’s partner port priority. Valid values
are 0 - 65535, with lower values given higher priority.
padminstate
lacpactive |
lacptimeout |
lacpagg |
lacpsync |
lacpcollect |
lacpdist |
lacpdef |
lacpexpire
Sets a port’s partner LACP administrative state. See aadminstate for valid
options.
padminsysid
padminsysid
Sets a default value to use as the port’s partner system ID. This is a MAC
address.
padminsyspri
padminsyspri
Sets a default value to use as the port’s partner priority. Valid values are 0
- 65535, with lower values given higher priority.

Enterasys C3G124-24 Specifications

General

Brand	Enterasys
Model	C3G124-24
Category	Switch
Language	English