show ipv6 traffic
Enterasys C3 Configuration Guide 29-29
Parameters
Defaults
If no interface is specified, information about traffic on all interfaces is displayed.
Mode
Router privileged execution: C3(su)->router#
Usage
Specify a logical, loopback, or tunnel interface to view information about traffic on a specific
interface. If you do not specify an interface, the command displays information about traffic on all
interfaces.
Example
The following example displays the output of this command.
C3(su)->router>show ipv6 traffic
IPv6 STATISTICS
Total Datagrams Received.................................. 116
Received Datagrams Locally Delivered...................... 116
Received Datagrams Discarded Due To Header Errors......... 0
Received Datagrams Discarded Due To MTU................... 0
Received Datagrams Discarded Due To No Route.............. 0
Received Datagrams With Unknown Protocol.................. 0
Received Datagrams Discarded Due To Invalid Address....... 0
Received Datagrams Discarded Due To Truncated Data........ 0
Received Datagrams Discarded Other........................ 0
Received Datagrams Reassembly Required.................... 0
Datagrams Successfully Reassembled........................ 0
Datagrams Failed To Reassemble............................ 0
Datagrams Forwarded....................................... 0
Datagrams Locally Transmitted............................. 876
Datagrams Transmit Failed................................. 0
Datagrams Successfully Fragmented......................... 0
Datagrams Failed To Fragment.............................. 0
Fragments Created......................................... 0
Multicast Datagrams Received.............................. 17
Multicast Datagrams Transmitted........................... 547
ICMPv6 STATISTICS
Total ICMPv6 Messages Received............................ 116
ICMPv6 Messages With Errors Received...................... 4
ICMPv6 Destination Unreachable Messages Received.......... 0
ICMPv6 Messages Prohibited Administratively Received...... 0
ICMPv6 Time Exceeded Messages Received.................... 0
ICMPv6 Parameter Problem Messages Received................ 0
ICMPv6 Packet Too Big Messages Received................... 0
ICMPv6 Echo Request Messages Received..................... 52
ICMPv6 Echo Reply Messages Received....................... 0
interface (Optional) Specifies the interface for which traffic information should be
displayed. Interface can be of the form:
vlan vlan-id
tunnel tunnel-id
loopback loop-id
To Next Page
Loading...
