Enterasys C3G124-24 User Manual

set newaddrtrap
Enterasys C3 Configuration Guide 11-33
Parameters
Defaults
If port-string is not specified, the trap function is set globally.
Mode
Switch mode, read-write.
Usage
This command enables and disables sending SNMP trap messages when a new source MAC
address is detected by a port. If the port is a CDP port, however, traps for new source MAC
addresses will not be sent.
The default mode is disabled globally and per port.
Example
This example enables the trap function globally and then on ports 1 through 5 in unit/slot 1.
C3(rw)->set newaddrtrap enable
C3(rw)->set newaddrtrap ge.1.1-5 enable
port-string (Optional) Enable or disable the new MAC addresses trap function on
specific ports.
enable | disable Enable or disable the new MAC addresses trap function. If entered
without the port-string parameter, enables or disables the function
globally. When entered with the port-string parameter, enables or
disables the function on specific ports.

Enterasys C3G124-24 Specifications

General

Brand	Enterasys
Model	C3G124-24
Category	Switch
Language	English