Keysight Technologies InfiniiVision 3000T X Series - :TRIGger:FORCe

1010 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
33 :TRIGger Commands
:TRIGger:FORCe
(see page 1276)
Command Syntax
:TRIGger:FORCe
The :TRIGger:FORCe command causes an acquisition to be captured even though
the trigger condition has not been met. This command is equivalent to the front
panel [Force Trigger] key.
See Also • "Introduction to :TRIGger Commands" on page 1007