To Next Page

To Previous Page

:MTESt Commands 24

Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 559

:MTESt:AMASk:YDELta

(see page 1276)

Command Syntax

:MTESt:AMASk:YDELta <value>

<value> ::= Y delta value in NR3 format

The :MTESt:AMASk:YDELta command sets the vertical tolerance around the

waveform for the automasking feature. The absolute value of the tolerance will be

added and subtracted to vertical values of the waveform to determine the

boundaries of the mask.

The vertical tolerance value is interpreted based on the setting specified by the

:MTESt:AMASk:UNITs command; thus, if you specify 250-E3, the setting for

:MTESt:AMASk:UNITs is CURRent, and the current setting specifies voltage in the

vertical direction, the tolerance will be ±250 mV. If the setting for

:MTESt:AMASk:UNITs is DIVisions, the same Y delta value will set the tolerance to

±250 millidivisions, or 1/4 of a division.

Query Syntax

:MTESt:AMASk:YDELta?

The :MTESt:AMASk:YDELta? query returns the current setting of the ΔY tolerance

for automasking. If your computer program will interpret this value, it should also

request the current measurement system using the :MTESt:AMASk:UNITs query.

Return Format

<value> ::= Y delta value in NR3 format

See Also • "Introduction to :MTESt Commands" on page 551

• ":MTESt:AMASk:UNITs" on page 557

• ":MTESt:AMASk:XDELta" on page 558

• ":MTESt:AMASk:SOURce" on page 556

• ":MTESt:SOURce" on page 581

Example Code • "Example Code" on page 551

Keysight Technologies InfiniiVision 3000T X Series User Manual

Questions and Answers: