Getting Started 3
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 63
Other Ways of Sending Commands
Standard Commands for Programmable Instrumentation (SCPI) can also be sent
via a Telnet socket or through the Browser Web Control:
• "Telnet Sockets" on page 63
• "Sending SCPI Commands Using Browser Web Control" on page 63
Telnet Sockets
The following information is provided for programmers who wish to control the
oscilloscope with SCPI commands in a Telnet session.
To connect to the oscilloscope via a telnet socket, issue the following command:
telnet <hostname> 5024
where <hostname> is the hostname of the oscilloscope. This will give you a
command line with prompt.
For a command line without a prompt, use port 5025. For example:
telnet <hostname> 5025
Sending SCPI Commands Using Browser Web Control
To send SCPI commands using the Browser Web Control feature, establish a
connection to the oscilloscope via LAN as described in the InfiniiVision
3000T X-Series Oscilloscopes User's Guide. When you make the connection to the
oscilloscope via LAN and the instrument's welcome page is displayed, select the
Browser Web Control tab, then select the Remote Programming link.
To Next Page
Loading...
Need help?
General
