Keysight Technologies InfiniiVision 3000T X Series - :STOP

228 Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide
6 Root (:) Commands
:STOP
(see page 1276)
Command Syntax
:STOP
The :STOP command stops the acquisition. This is the same as pressing the Stop
key on the front panel.
See Also • "Introduction to Root (:) Commands" on page 194
• ":RUN" on page 224
• ":SINGle" on page 226
Example Code • "Example Code" on page 224