Keysight Technologies InfiniiVision 3000T X Series - :TRIGger:GLITch:QUALifier

:TRIGger Commands 33
Keysight InfiniiVision 3000T X-Series Oscilloscopes Programmer's Guide 1043
:TRIGger:GLITch:QUALifier
(see page 1276)
Command Syntax
:TRIGger:GLITch:QUALifier <operator>
<operator> ::= {GREaterthan | LESSthan | RANGe}
This command sets the mode of operation of the glitch pulse width trigger. The
oscilloscope can trigger on a pulse width that is greater than a time value, less
than a time value, or within a range of time values.
Query Syntax
:TRIGger:GLITch:QUALifier?
The :TRIGger:GLITch:QUALifier? query returns the glitch pulse width qualifier.
Return Format
<operator><NL>
<operator> ::= {GRE | LESS | RANG}
See Also • "Introduction to :TRIGger Commands" on page 1007
• ":TRIGger:GLITch:SOURce" on page 1045
• ":TRIGger:MODE" on page 1016